Our Previous Work

Take a look at some of the parts and projects we have designed and produced, from custom replacement components to practical solutions for everyday use.

Replacement Hubcap

Here’s a replacement hubcap that we designed and produced. The original is shown on the left, with our replacement on the right.

Intake Replacement

This is a replacement intake designed to match the original component, shown alongside the original for comparison. This particular intake replaces one of the headlights.

Ski Pole Handles

These ski pole handles were designed to replace the original handles, which had snapped. The replacements have been reinforced and are now stronger than the stock parts.

Replacement Gears

We made a replacement gear after the original had snapped. Our replacement was made stronger, and we made sure that both sets of gears meshed perfectly.

Fibreglass Speaker Horn Mould

Here is a large mould that we made so our customer could produce a fibreglass speaker horn. The mould was designed and produced to create the required shape accurately.

Tweeter Horn Mould

Here is a small tweeter mould that we made so our customer could produce a replica speaker. It was designed and produced to create the required shape accurately.

Stronger Gears

We made these replacement gears after all of the original gears had snapped from constant use. The replacements use a different tooth profile, which is stronger than the original design.

NVIDIA Jetson Nano Case

A custom case produced to house an NVIDIA Jetson Orin Nano Developer Kit, protecting the circuit boards while allowing rubber feet to be installed.

LEVC Taxi Ramp Handle

A replacement handle for the wheelchair ramp on an LEVC taxi. The original handle had broken and replacement parts were no longer available, so we designed and produced a replacement to restore the ramp’s operation.